[Minigolf] Balls don't enter the hole and out of bound problem

This happens way to much to me. Another problem I had was on hole 8. (Spin Cycle) I ball entered through the middle hole and went down the pipe. Then rolled over the wall and said out of bound. I didn’t take a pic sry.

Spin cycle was a prototype level by Dom and will most likely be either redone or discarded.

As for the friction issues, we’re looking into increasing the amount of time before the goes to sleep (putting position), as we’re seeing a lot of cases of balls stopping on hills.

1 Like

Thanks for your report! This has been forwarded straight to our Trello board. You can track its status there (it takes a couple minutes to show up on Trello).

1 Like